The Wilson Cellular Amplifier / Repeater has a better receiver than what's in your cellphone. Its advanced electronics are very sensitive and able to receive small signals which would go undetected by most cellphones. It also has a better transmitter with double the power of your cellphone. This allows your voice to be heard by distant cell sites, increasing coverage up to 50 miles or more.

A cellphone using our amplifier is safer and will use less battery power because the phone thinks it's much closer to a cell site than it actually is. Phones vary their power output based on their proximity to cell sites. Therefore, your phone transmits less power - resulting in safer use and longer battery life.

This Amplifier-Repeater greatly improves signal strength inside a building when using your cellular phone. It does this without a physical connection to your phone, allowing you to walk freely during a call. It even allows multiple phones to be used simultaneously.

The signal is received by the outside antenna from the cell site. It is then amplified and repeated to your phone through the inside antenna. When the phone transmits it is received by the inside antenna. It is then amplified/repeated to the cell site through the outside antenna. Wireless operation - no physical connection to cellular phone.

Wilson Cellular Amplifiers extend cellular services in poor coverage areas by amplifying both transmit and receive signals. The amplifiers reduce problems with signal fades and dropped calls while improving voice quality, service range and access. These multi-mode amplifiers are designed to offer a cost-effective solution for use in buildings. Wilson Cellular amplifiers are network compatible and enhance the cellular phone user`s satisfaction without comprising the operation of the cellular system.

Features:

• Allows multiple phones to be used simultaneously
• Maximum 3 Watts output power
• Designed for all cellular systems: AMPS, CDMA, EDGE, GPRS, GSM and TDMA (not compatible with Nextel/iDEN)
• Automatic Gain Control
• Overload Protection Circuit - Protects cell system from overload
• Automatic Reset - if overload occurs
• FCC Type Accepted

Includes:

• Interior low profile antenna
• Cigarette lighter power plug
• 6' Extension cable
• Mini 'antenna' (359914)

Requires Exterior Antenna:

• Recommend Wilson Cellular Dual-Band Magnetic Mount antenna or NMO (through-the-roof) Mount antenna
• Wilson Cellular Dual-Band Glass Mount antenna not recommended.