The Wilson Cellular Amplifier / Repeater has a
better receiver than what's in your cellphone. Its advanced electronics are very
sensitive and able to receive small signals which would go undetected by most
cellphones. It also has a better transmitter with double the power of your
cellphone. This allows your voice to be heard by distant cell sites, increasing
coverage up to 50 miles or more.
A cellphone using our amplifier is safer and
will use less battery power because the phone thinks it's much closer to a cell
site than it actually is. Phones vary their power output based on their
proximity to cell sites. Therefore, your phone transmits less power - resulting
in safer use and longer battery life.
This Amplifier-Repeater greatly improves signal
strength inside a building when using your cellular phone. It does this without
a physical connection to your phone, allowing you to walk freely during a call.
It even allows multiple phones to be used simultaneously.
The signal is received by the outside antenna
from the cell site. It is then amplified and repeated to your phone through the
inside antenna. When the phone transmits it is received by the inside antenna.
It is then amplified/repeated to the cell site through the outside antenna.
Wireless operation - no physical connection to cellular phone.
Wilson Cellular Amplifiers extend cellular
services in poor coverage areas by amplifying both transmit and receive signals.
The amplifiers reduce problems with signal fades and dropped calls while
improving voice quality, service range and access. These multi-mode amplifiers
are designed to offer a cost-effective solution for use in buildings. Wilson
Cellular amplifiers are network compatible and enhance the cellular phone user`s
satisfaction without comprising the operation of the cellular system.
|
Specifications |
| Frequency:
|
806-821MHz
Uplink 851-866MHz
Downlink |
| Gain: |
50dB / 50dB |
| Linear Output Power |
+30dBm |
| Max RF (up/down): |
+30dBm / +30dBm |
| Noise Figure (down): |
3dB nominal |
| Flatness (up/down): |
+/- 2.5 |
| Power Consumption: |
13.8V, 1.5A |
| Connectors |
FME-Male 50 Ohms |
Features:
Advanced Electronics
Receive & Transmit Better Than Your Cellphone*
Wireless Operation - No
Physical Connection to Cellphone
Allows Multiple Phones to
be Used Simultaneously
Significantly Increases
Your Cellphone's Range on Send & Receive
Safer Than Using Your
Cellphone Without An Amplifier**
Extends the Life of Your
Cellphone's Battery**
FCC Type Accepted
When designing your system,
please be sure to allow for 45' of separation between the interior and exterior
antennas (20' which must be vertical).
Compatibility:
- Compatible with iDEN Carriers (Nextel,
Southern LINC, Mike). Compatible with iDEN Cellular calls and Direct Connect.
- Not compatible with 800MHz Cellular (Verizon,
AT&T, etc) or 1900MHz PCS (AT&T GSM, Sprint PCS, T-Mobile, Qwest)
