Installation

Good Reception: Outside of a window
Locate a window where you get signal.

1. Mount the Signal Antenna outside of the window
2. Place the Base Unit across the room (15 feet away) where you want to create a Cell Zone™.
3. Attach the coax cable to the Signal Antenna.
4. Run the coax cable from the Signal Antenna through the window to the Base Unit using a window entry kit (optional).
5. Attach the Antenna to the Base Unit and position it so that it is at a 90 degree angle to the Base Unit.
6. Set the Base Unit on a furniture piece.
7. Attach the Power Supply to the Base Unit and plug the power supply into an outlet. See the Troubleshooting section if a Red light lights up.

Best Reception: Attic or Roof Installation
The following instructions are recommended for the best reception.
Once you have confirmed that you have a cell phone signal either outside your home or inside your attic, you are ready to install the Signal Antenna using the supplied mounting brackets, Signal Antenna, and coaxial cable.

• Identify the best location around your home with the strongest signal (best signal is typically found on the roof) for attachment of the antenna mounting bracket. For good the signal reception, install the Signal Antenna at the highest possible point in your area. Avoid placing the antenna within 3 feet (1 meter) of metal objects (pipes, metal siding, A/C unit, etc.)
• Attach the mounting bracket so that when the Signal Antenna is attached, it will be positioned vertically.
• Mount the Signal Antenna to the mounting bracket, making sure that the antenna is positioned vertically
• Unroll the RG6 coaxial cable supplied with your zBoost Series kit removing any loops or kinks and attach to the base of the Signal Antenna.
• Run the coax cable from the Signal Antenna through the window to the Base Unit using a window entry kit (optional).
• Attach the Antenna to the Base Unit and position it so that it is at a 90 degree angle to the Base Unit.
• Set the Base Unit on a furniture piece.
• Attach the Power Supply to the Base Unit and plug the power supply into an outlet. If a Red light lights up, try further separating the antennas and then see the Troubleshooting section of the manual.